Universal Joint Mechanism
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Universal Joint Mechanism
Can any PTC Creo users recreate this joint?
<click on image to zoom>
<see attachment for animation>
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
- Labels:
-
Mechanism Design
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Dan! Awesome to hear from you, love the attached annimation. Hopefully our PTC Creo heroes can lend a hand.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
It shouldn't be that difficult.
Dan, is this a challenge or a request?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Just for fun. I was mesmerized by the animation. What kind of application would this joint be useful for?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Dan, this is what makes most cars run... it is a universal joint. Steering columns have them and drive-shafts (except the front wheel drive units) use them. The interesting thing about them is the periodicity in the rotation so they are normally used in pairs to counteract that artifact.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Here is a "constant Velocity" application where the periodicity is counteracted. This is only for illustrative purposes, of course but this is how Chevy 4WD has managed a high angle driveline without tearing itself apart (although some would argue that view). The idea is that you can put a double U-joint in a single casting and have the input and the output be exactly the same.
Yes, you can also exaggerate the action by changing the synchronicity of the 2 joints... changing their phase.
This has been a controversial implementation for a long time now:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Nice one
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Nice to see you back on here Dan.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Thanks, Mike. It's good to be seen.