cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Projection query

RH_10122575
12-Amethyst

Projection query

Hi,

 

When projecting a circle it only projects half of it. 

 

1. Can it be set to project it all.

2. ideally just project the centre point.

1 ACCEPTED SOLUTION

Accepted Solutions

Make sure to select the loop (or tangent chain) of the circle as Creo bisects all circles. You cannot project the center point explicitly but is implicit if the projection of the circle is also a true circle. You can include a dtm point in the sketch of the circle creation and use an axis to get the center projected on to another surface.

 

See this Creo 4 part as an example.

========================================
Involute Development, LLC
Consulting Engineers
Specialists in Creo Parametric

View solution in original post

1 REPLY 1

Make sure to select the loop (or tangent chain) of the circle as Creo bisects all circles. You cannot project the center point explicitly but is implicit if the projection of the circle is also a true circle. You can include a dtm point in the sketch of the circle creation and use an axis to get the center projected on to another surface.

 

See this Creo 4 part as an example.

========================================
Involute Development, LLC
Consulting Engineers
Specialists in Creo Parametric
Top Tags