What do the options in the table repeat area definition in the drawing module represent?

[NT_10507751]

These options are too short, not a complete word, and the PTC help document has no relevant explanation, I don’t know what they mean, can anyone tell me, thank you!

I hope that the PTC help documentation can add explanations for all these options and sub-options.

[FabianWolf · Accepted solution]

This and the sub-chapters might help:

http://support.ptc.com/help/creo/creo_pma/usascii/electrical_design/cable/about_parameters_in_report_tables.html#

[BenLoosli]

Look at this page, it may help a little.

System Parameters for Drawings (ptc.com)