CREO7/NC How to set Helical Pitch for Cutline Milling when Milling a Hole

[BH_8851954]

Hello, All

When I use Cutline Milling to mill  a hole, I use Type_Helical , however, I found that I can not set Helical Pitch for Helical milling.

Can anyone help me on this issue?

[bmuller · Accepted solution]

Have you tried adjusting STEP_OVER to a smaller value?

[BH_8851954]

you are absolutely right, the pitch is controlled by STEP_OVER.

thanks for your help!