Skip to main content
J
JasonPensack1-Visitor
1-Visitor
January 22, 2013
Question

Toolpath skipping over hole

  • January 22, 2013
  • 1 reply
  • 1001 views

I am using Volume Rough to profile the inside of a pocket with a window mill and the setting on profile only. There are holes that break into this pocket and the toolpath wants to skip over these holes. I have tried opening the reference model and inserting a fill over them (which is why the hole looks filled in the picture) but that still doesnt work. The model is a .stp model. I am using creo 2 m030.

Untitled.jpg


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

S
SteveLucas1-Visitor
1-Visitor
January 22, 2013

Jason,

Holes are a pain in the A__ with mill window.If I see a hole in the bottom of a pocket I use mill volume.You are suppose to be able to exclude holes or features or close the holes but I can never get it to work and I spend more time messing with it than it takes to build a mill volume and the mill volume doesn't see the holes.

Steve

S
SteveLucas1-Visitor
1-Visitor
January 22, 2013

Jason,

I should have looked closer at your picture.You can also select all the pockets and build your volume to the lowest Z level and the trim the volume to the model so it will mill all the levels with 1 volume same as mill window.

Steve

Terms & ConditionsCookie settingsAccessibility statement