I don't know if anyone knew this parameter that i discovered this morning while trying to get the tool to stop retracting between passes. But it does stop the retracts while trajectory milling a profile.
This seems to allow you to use lead in and out and move to the next cut without a retract in trajectory milling!!
I didn't think it was possible.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
