Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X
While some bad bugs concerning the symbolics, especially the indefinite integral and the inverse laplace transform were corrected since Version 14, I again found what seems to be another bug with the symbolic integral (see attched worksheet). Mathcad adds a wrong factor 2 to the solution.
Can somebody confirm the bug an log it for correction, please.
One method for symbolic bugs check:
See too (Mathcad 15 and Mathcad Prime 2.0):
I will log this issue (for Mathcad 15 M010 and Mathcad Prime 2.0 F000) to the PTC's technical support.
Possible workaround..
This issue was reported as a SPR 2133542 (Severity: High).
Thanks!
One would think that it should not be THAT difficult to correct those integral tables. Since the introduction of MC14 Mathcad suffered a lot from wrong symbolic integrals and invlaplace. I know its muPad, but so what. MC14 was introduced in 2007, I think - thats 5(!) years ago!
Sincerely
WR
No problem.