cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Using Functions

dm-3
1-Newbie

Using Functions

Hi,

I have a calculation sheet and the requirement is we need to know, when we input 3(positive) variables, how we can provide the auto loop in the calculation to check for different possible load cases, for example, we have three loads acts in positive direction and which results some reaction load at its support points and with this there will be eight possible cases of loading with deferent direction. Our requirement is to determine worst possible reaction load out of this eight cases with providing input variables in one case i.e Fx=+100kN Fy=50kN and Fz=150kN. I have attached an Example file for your start up

--

Dhinesh

1 ACCEPTED SOLUTION

Accepted Solutions
StuartBruff
23-Emerald II
(To:dm-3)

Dhinesh wrote:

Stuart,

Yes its similar to what you did but I have 8 combinations like mentioned below.

Fx Fy Fz

150 50 150

150 50 -150

150 -50 -150

-150 -50 -150

-150 -50 150

-150 50 150

150 -50 150

-150 50 150

Just set F.x to 150 kN and change the step sizes (dx,dy,dz) to twice the given values.

Stuart

View solution in original post

3 REPLIES 3
StuartBruff
23-Emerald II
(To:dm-3)

I have a calculation sheet and the requirement is we need to know, when we input 3(positive) variables, how we can provide the auto loop in the calculation to check for different possible load cases, for example, we have three loads acts in positive direction and which results some reaction load at its support points and with this there will be eight possible cases of loading with deferent direction. Our requirement is to determine worst possible reaction load out of this eight cases with providing input variables in one case i.e Fx=+100kN Fy=50kN and Fz=150kN. I have attached an Example file for your start up

Do you mean something like the attached?

Stuart

Stuart,

Yes its similar to what you did but I have 8 combinations like mentioned below.

Fx Fy Fz

150 50 150

150 50 -150

150 -50 -150

-150 -50 -150

-150 -50 150

-150 50 150

150 -50 150

-150 50 150

StuartBruff
23-Emerald II
(To:dm-3)

Dhinesh wrote:

Stuart,

Yes its similar to what you did but I have 8 combinations like mentioned below.

Fx Fy Fz

150 50 150

150 50 -150

150 -50 -150

-150 -50 -150

-150 -50 150

-150 50 150

150 -50 150

-150 50 150

Just set F.x to 150 kN and change the step sizes (dx,dy,dz) to twice the given values.

Stuart

Top Tags