Using Functions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Using Functions
Hi,
I have a calculation sheet and the requirement is we need to know, when we input 3(positive) variables, how we can provide the auto loop in the calculation to check for different possible load cases, for example, we have three loads acts in positive direction and which results some reaction load at its support points and with this there will be eight possible cases of loading with deferent direction. Our requirement is to determine worst possible reaction load out of this eight cases with providing input variables in one case i.e Fx=+100kN Fy=50kN and Fz=150kN. I have attached an Example file for your start up
--
Dhinesh
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Dhinesh wrote:
Stuart,
Yes its similar to what you did but I have 8 combinations like mentioned below.
Fx Fy Fz
150 50 150
150 50 -150
150 -50 -150
-150 -50 -150
-150 -50 150
-150 50 150
150 -50 150
-150 50 150
Just set F.x to 150 kN and change the step sizes (dx,dy,dz) to twice the given values.
Stuart
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
I have a calculation sheet and the requirement is we need to know, when we input 3(positive) variables, how we can provide the auto loop in the calculation to check for different possible load cases, for example, we have three loads acts in positive direction and which results some reaction load at its support points and with this there will be eight possible cases of loading with deferent direction. Our requirement is to determine worst possible reaction load out of this eight cases with providing input variables in one case i.e Fx=+100kN Fy=50kN and Fz=150kN. I have attached an Example file for your start up
Do you mean something like the attached?
Stuart
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Stuart,
Yes its similar to what you did but I have 8 combinations like mentioned below.
Fx Fy Fz
150 50 150
150 50 -150
150 -50 -150
-150 -50 -150
-150 -50 150
-150 50 150
150 -50 150
-150 50 150
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Dhinesh wrote:
Stuart,
Yes its similar to what you did but I have 8 combinations like mentioned below.
Fx Fy Fz
150 50 150
150 50 -150
150 -50 -150
-150 -50 -150
-150 -50 150
-150 50 150
150 -50 150
-150 50 150
Just set F.x to 150 kN and change the step sizes (dx,dy,dz) to twice the given values.
Stuart
