Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hi,
I'm brand new to Mathcad so apologies if this is a silly question. I'm trying to figure out how to check inputs for columns 0 and 1 to provide an output in column 3. In this case colum 0 input is 100, column 1 input is 3, and therefore column 3 output should be 1/2500.
With Excel i would use XLOOKUP and use '&' operator to combine 2 inputs. However, I can't figure out a way of doing this (yet) with Mathcad. Any advice?
Thanks,
Ciaran
Solved! Go to Solution.
Hi Ciaran,
welcome to the community.
Here is one way to do it.
Cheers
Terry
Thanks very much, that was really helpful!
Ciaran
Thank you very much, that was really helpful! That solution worked perfectly.
Ciaran