Appropriate Plotter (replacement for designjet1255cm+)

[harter]

Dear group.



I´m looking for an appropriate replacement for our old designjet 1255. I
know that plotter configuration is still not easy with pro/E so I want to
make sure that everything will work smoothly after switching to a new
plotter. Unfortunately PTC on their “certified hardware page”gives you only
HP plotters and some of them are quite old




Are there any recommendations?



Thanks in advance. Rainer



--

Rainer Harter

Fraunhofer-Institut für Physikalische Messtechnik IPM,
VID/Systemadministration und IT-Sicherheit

Heidenhofstr.8, 79110 Freiburg, Germany

Telefon +49 761 8857-320 rainer.harter@ipm.fraunhofer.de

www.ipm.fraunhofer.de




This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[dgallup]

We went with an HP DesignJet T2300 because we wanted the scanning/copying capability as well as the plotting. Took a little bit of setup as we were switching from a really old DesignJet 750 but it works perfectly. The copying capability let us eliminate an OCE large format copier andy the scanning let us scan in a lot of old hand drawn tooling drawings.

PTC quality philosophy: We've upped our quality standards. Up yours.