Hey guys,
I have a question about the buckling results aquired from my analysis.
I am busy analyzing a component that has a global buckling mode the opposite direction of which it is being pushed as a result of an applied force.
Negative result filter settings are on.
When I repeat the analysis with the filter off it swings in both directions, the expected direction the loads pushes it and the opposite.
I am very skeptic if the results produced are reliable.
Does anyone have any experience which such results?
Does the visual deformation direction have to be the direction the forces push the component to?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
