Creo 7 will not start

[SB_4354308]

Upon starting Creo 7 on my computer I receive a warning message list that shows license request failures.  The license is on a coworkers computer and Creo 7 starts for him. Creo 5 still starts for me working off of the same license, but will not allow Creo 7 to start.  Attached is the message I get.

[BenLoosli]

It looks like the 2 locked node licenses are Creo 7 (version 38.0) while the FoundationAdv is for Creo 5 (version 36.0).

[SB_4354308]

Since his computer has the license and those 2 node licenses being locked to his computer.  Is that why I am unable to run Creo 7 on my computer?

[BenLoosli]

Yes

The floating licenses are for Creo 5, which is why you can run it.

[SB_4354308]

Thanks for your help.   We will look into getting those licenses unlocked so I can use Creo 7.

[MartinHanak]

Hi,

if license is locked then this means that it cannot float. It can be installed on single computer and launched on it, only.

Maybe you can buy and upgrade from locked license to floating license.