cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Visit the PTCooler (the community lounge) to get to know your fellow community members and check out some of Dale's Friday Humor posts! X

Not able save as assembly model as single solid file without internal.

DD_9618373
4-Participant

Not able save as assembly model as single solid file without internal.

I am using Creo Parametric Release 4.0 and DatecodeM140

We are using creo parametric software.
We are planning to send the assembly model to another customer. During model conversion we want to save the assembly model as single solid (IGES or STEP format) with out internal parts (only outer view geometry only).
For the above requirement we are not able to save the assembly model in creo parametric.

Here are the errors that I faced
Not able save as assembly model as single solid file without internal.
1 ACCEPTED SOLUTION

Accepted Solutions
Chris3
20-Turquoise
(To:DD_9618373)

Create a rep that hides internals and then step it out and import it back in with the hidden config below turned on.

intf3d_in_as_part YES

 

Note that this config option is hidden because it is not fully supported. It doesn't support mixed units and it can cause Creo to crash. With it enabled though you can import a step assembly as a single merged part.

View solution in original post

1 REPLY 1
Chris3
20-Turquoise
(To:DD_9618373)

Create a rep that hides internals and then step it out and import it back in with the hidden config below turned on.

intf3d_in_as_part YES

 

Note that this config option is hidden because it is not fully supported. It doesn't support mixed units and it can cause Creo to crash. With it enabled though you can import a step assembly as a single merged part.

Top Tags