cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Learn all about PTC Community Badges. Engage with PTC and see how many you can earn! X

Pro-E crashes when MMB is pressed in assembly mode

AjitTipnis
1-Visitor

Pro-E crashes when MMB is pressed in assembly mode

I am new at this , so please forgive if I use wrong etiquette.

I am using PRO-E Wildfire 5., student edition

I have a computer with 6 MB of memory. When I assemble a few parts, and try tio change view using the middle mouse button, suddenly the program stos working. As if it was closed, without saving any work. Is this a memory issue? I think my video card is adequate.

Thanks.

Ajit

Message was edited by: Ajit Tipnis Per reply from nonamepicked here is iformation you requested

. -Brand HP-Pavilion NP247AA-ABA p6107c

SystemEnclosure Type: Desktop

-CPU -exact memory (6 MB????????????????????????????????????)

6144 Megabytes Usable Installed Memory

Slot 'DIMM0' has 2048 MB Slot 'DIMM1' has 1024 MB

Slot 'DIMM2' has 2048 MB Slot 'DIMM3' has 1024 MB

-OS Windows 7 Home Premium (X64)

-Graphic Card EVGA GeForce 512 MB DDR5 Has open GL 3.1 support Processor:

Board: PEGATRON CORPORATION Benicia 1.01

Serial Number: Bus Clock: 800 megahertz

BIOS: American Megatrends Inc. 5.39 05/06/2009

As per your note, I am also openiong a new discussion as same name but this information added.

Thanks.

Ajit


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
2 REPLIES 2

Please give more information:

-Brand

-CPU

-exact memory (6 MB????????????????????????????????????)

-OS

-Graphic Card

Without these information it's only a look in a crystal ball.

Thanks.

The graphics driver needed updating.

Announcements
NEW Creo+ Topics: PTC Control Center and Creo+ Portal


Top Tags