Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
How does one go about resetting a restricted parameter in a drawing? I have updated the permissible values in my definition file, but I cannot get these new values into the drawing. I have even tried deleting the parameter,saving the drawing, restarting Pro-E and then recreating the parameter - it still has the obsolete restrictions. If I create the parameter in a part the available values are correct. Any other ideas? I don't want to have to start from scratch with the drawing...
Thanks,
Josh