I'm following a coworker's technique for modeling a surface that rises and falls along a rectangular path. His worked successfully with extrude features that terminate on the surface and mine is having issues with those later features.
I isolated those surfaces in the attached part and am hoping that you can help with tips or techniques to correct two issues:
1. The section doesn't seem to remain constrained along the trajectory.
2. The start stop point, circled below, seems to show an inconsistancy that may be causing issues with the later features that fail to terminate to this surface.
Release: 5.0 Date Code: M130
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
