cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

View max and dynamic query dependent on stress level settings?

jglim
1-Newbie

View max and dynamic query dependent on stress level settings?

 

Hello I'm using Creo 1.0

 

I've a shell model and showing Von Mises stress on the maximum of the top/bottom of shell.

I've set the stress level between 0 and 240 MPa. The view max shows a stress of 271 MPa and the dynamic query shows stresses between 240 and 270 in the red area.

When I set the maximum stress level to 300 MPa the view max is suddenly 322 MPa and the initial values of the dynamic query don’t match the colored areas.

Anyone any idea what is going on here?

Stress levels at 240 MPa

Same picture, stress level at 300 MPa.

 


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements