cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

Wildfire 4.0 upgrade to Creo

elau-2
1-Newbie
1-Newbie
‎May 13, 2016 01:40 PM
‎May 13, 2016 01:40 PM

Wildfire 4.0 upgrade to Creo

I am new to this company which uses PTC Wildfire 4.0 wanting to upgrade to Creo.

We have a license server and some workstations with Wildfire 4.0 installed on each workstation.

Any upgrade path or documentation that you can share with?

Thanks.

Eric

Labels:
0 Kudos
Notify Moderator
3 REPLIES 3
BenLoosli
23-Emerald II
23-Emerald II
(To:elau-2)
‎May 13, 2016 02:08 PM
‎May 13, 2016 02:08 PM

Are you using a PDM system with your Wildfire installation, as that will influence how you do your upgrade?

We use a single installation on a server, so everyone gets upgraded with a single installation.

A Creo upgrade is relatively easy, just install, copy over any customized files, like config.pro, hole files, etc, and go.

0 Kudos
Notify Moderator
Mahesh_Sharma
22-Sapphire I
22-Sapphire I
(To:elau-2)
‎May 13, 2016 02:11 PM
‎May 13, 2016 02:11 PM

Eric,

Some of the articles about license and installation of Creo are available at:

https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS26798

https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS170689

0 Kudos
Notify Moderator
zzhen
1-Newbie
1-Newbie
(To:elau-2)
‎May 14, 2016 12:35 AM
‎May 14, 2016 12:35 AM

Please refer to Creo Parametric 3.0 Upgrade Resource Center https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS189753

0 Kudos
Notify Moderator
Top Tags