annotation help in wildfire 4

[ptc-5861883]

need help!!!

i am using Pro-E wildfire 4 and have created a number of annotations by insert>annotation feature>note.

This is fine they are showing in the part fine as they should.

However i need them to show in the assemblies that the part is in, but they are not showing.

any idea how to get them to show. i have gone through the config.pro and cannot find a command to make them show, or an option to get them to show.

any ideas???

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[neomechanikos]

Are they turned off in an assembly layer?

[ptc-5861883]

No i have checked the layers and unhidden all lauers to check.

Was my first check though.

[Mahesh_Sharma · Accepted solution]

Hi Adam,

Set config option visible_annotations_scope as all and restart Pro/ENGINEER.

[ptc-5861883]

thanks i had done that but hadnt restarted pro-e, which i have now done and all is showing as it should.

thanks for your help.