Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily.
X
We have a multi sheet drawing where every sheet has a different model, and likely a different size format. There are drawing hole charts on some of these sheets to locate the hole position. If the active model is changed the text size within the charts of different models changes.
Say the active model of the drawing is changed to one that uses a hole chartt on a dsize format- then the text in hole charts on the bsize sheets gets bigger than the table.
I don't know if it is a glitch or if there is some dtl or other config that needs set. I will try to post screen shots.
any help would be appreciated.
Eric Henriksen Entegee Engineering Davenport Iowa
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.