Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
i am facing a problem in saving efx extension file . file is attached
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
EFX file extension is same as of parts and assembly (.prt and .asm) for Creo Parametric 2.0. When you will save a Frame assembly extension will be *.asm and frames/parts will save as *.prt.
EFX file extension is same as of parts and assembly (.prt and .asm) for Creo Parametric 2.0. When you will save a Frame assembly extension will be *.asm and frames/parts will save as *.prt.
mahesh is right abt extension. However I faced similar problem like creating the efx elements but couldnt save and that was becasue i overlooked the non saving of un regenerated models. Alos check you have full afx license instead of afx lite.
