Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hi,
I have a set of data coming in to thingworx from an industrial thing via opc aggregator. The data is fine in a Mashup as i can control the number of places of decimal in the mashup control...
But when I send this data to vuforia, there is no control of places of decimal so I'm getting huge data values.
Is there any way to control this in thingworx to control places of decimal at the "industrial thing" level?
Thanks,
Paul.
Solved! Go to Solution.
Hi Paul,
You can add data filters on your bindings within Vuforia Studio to control the length of data being displayed. This post may be helpful: https://community.ptc.com/t5/Studio/Can-t-round-digtial-value-with-decimal-part-of-a-properties/m-p/607175#M5609
Hi Paul,
You can add data filters on your bindings within Vuforia Studio to control the length of data being displayed. This post may be helpful: https://community.ptc.com/t5/Studio/Can-t-round-digtial-value-with-decimal-part-of-a-properties/m-p/607175#M5609