Animation and model transparency [what is the expected behaviour?]

[nqwifly]

When I set the whole model's opacity to 0.1, and start animation the model will show -by default- animated parts with opacity = 1. Which is good, i'm expecting my user to see only the animated part, not the whole model.

However, the animated parts are not all of them will be shown (opacity = 1) only some of it.

for example, in creo illustrate

on this step, I started by flashing the highlighted parts, then followed by unscrewing the nut and bolt. In Vuforia Studio/View, while the model is transparent it only shows the unscrewing with opacity = 1 (while flashing is not shown following model's transparency).

- I'm not sure what is the exact behaviour I'm expecting?

- What is the best practice for only showing the animated (instruction related) part?

Regards,

[nqwifly · Accepted solution]

I found this post, which recommends to control overall behaviour/transparency through Creo Illustrate:

https://community.ptc.com/t5/forums/searchpage/tab/message?advanced=false&allow_punctuation=false&filter=location&location=forum-board:studio&q=opacity%20mobile%20phone