cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

How to hold View value to "Design" in part creation

LeoWNC
3-Visitor

How to hold View value to "Design" in part creation

Dear all,
I'm trying to hold "design" selection for attribute "View" during the creation of a part in Windchill 10.1 v M040. There are two views, Design and Manufacturing.
View attribute does't support default option. If I remove the attribute from the "Create New Layout", its value is unassigned; and it's can't be accetped.
I followed this article:
https://www.ptc.com/en/support/article/CS286220?

but it does't work. Probably there is something in system configuration that collides with the provided solution .

Do You have any suggestions?
Tnx

2 REPLIES 2
jvonzastrow1
14-Alexandrite
(To:LeoWNC)

You can set the default view with preference "Default Part View"

MichaelChatel
20-Turquoise
(To:LeoWNC)

Hi, to add to jvonzastrow1's response, check out this knowledge article, we have on this:

 

https://www.ptc.com/en/support/article/CS30181

 

As he mentioned, Default Part View.

 

If you have trouble with this, I'd suggest opening a Support case, to help you walk through it.

 

Mike

 

 

 

Top Tags