Can we use a specific parameter to control whether another parameter is designated or not?
‎Mar 21, 2023
11:06 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Mar 21, 2023
11:06 PM
Can we use a specific parameter to control whether another parameter is designated or not?
Hi,
Can we use a specific parameter to control whether another parameter is designated or not?
Linked to topic - https://community.ptc.com/t5/3D-Part-Assembly-Design/Unchecking-Designate-parameters/m-p/754245#M121251
Appreciate your help.
Labels:
- Labels:
-
Assembly Design
-
Product Data MGMT
3 REPLIES 3
‎Mar 22, 2023
03:25 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Mar 22, 2023
03:25 AM
I think this is duplicate of mentioned discussion.
Martin Hanák
‎Mar 23, 2023
03:53 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Mar 23, 2023
03:53 AM
Hi,
This post is developing the topic referenced from 2021. Let's see if the Community can chime in.
Regards,
Andra
Andra
‎Mar 23, 2023
04:17 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Mar 23, 2023
04:17 AM
Hi,
in my first reply I did not mention the right discussion. The right link is https://community.ptc.com/t5/3D-Part-Assembly-Design/How-to-control-designated-parameters-in-Creo-Parametric/m-p/863451
Martin Hanák