Counterbored Holes using Hole Table.

[BT_12786803]

I am using Creo Parametric Release 8.0 and Datecode8.0.0.0

I create counterbored holes using the hole feature in my model. When I create my 2D drawing, I create a hole table. The table will give me the through diameter of the hole, but I can't get it to show the counter bore diameter, or the counter bore depth. How do you add the counter bore diameter and depth?

[Mahesh_Sharma]

Hi @BT_12786803 

You may try adding hole feature parameters in table using Hole Table > Add > Parameters > Select > Select Feature and add required parameters.

I hope this will help.

Thanks.  

[mkajdan]

Use the parameters for the hole features in custom hole table columns.

[BT_12786803]

Thank you. How are you able to insert the CBORE_DEPTH & CBORE_DIAMETER? Where are you accessing the table in the first picture you shared? 

[mkajdan · Accepted solution]

To insert the counter bore depth and diameter, add a new row, Parameters then enter the parameter name.  You can access the feature parameters by right clicking on the feature in the model tree then selecting Parameters.