Skip to main content
A
aturcat1-Visitor
1-Visitor
November 15, 2017
Question

Generate fixed length tubes

  • November 15, 2017
  • 1 reply
  • 2789 views

Hello,

 

I would like to know if it is possibled to generate a tube with a fixed length on Creoparametric2.0

 

Thank you for your response

Ambroise.

1 reply

B
23-Emerald III
BenLoosli23-Emerald III
23-Emerald III
November 15, 2017

You can create a tube of any length.

If you mean a flexible tube that conforms to a spline or multiple curves, you can, but you have to build your base curve to be your desired length.

 

    A
    aturcat1-VisitorAuthor
    1-Visitor
    November 16, 2017

    Hello,

     

    Thank you for your answer

    What I am looking for is a parameter that sets the length.

    A flexible tube is exactly what it try to design, but I autoroute the wires after defining a network, and i think there is a way to tell "go from point A to B, with such length", is that possible?

     

    Thank you

    Ambroise

    Terms & ConditionsCookie settingsAccessibility statement