Getting error message "The section is not perpendicular in this view: select again."

[ArekTRI]

Hi Creos,

I am facing this error which was registered as SPR 1410164.

https://www.ptc.com/en/support/article?n=CS51439&source=SPR%20Viewer

(Getting error message "The section is not perpendicular in this view: select again." when trying to arrows in a drawing view in Pro/ENGINEER and Creo Elements/Pro)

Is this bug repaired?

Thank you.

Arek

[StephenW]

Well, unlikely since it says it "works to product spec". Is this an offset x-sec? 

Resolution

• Reported to R&D as SPR 1410164
• Works to product specification for Pro/ENGINEER，Creo Elements/Pro and Creo Parametric
• For an offset X-sec, the arrows can only be shown in a view in which the sketching plane for the xsec is flat to screen.