cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Help us improve the PTC Community by taking this short Community Survey! X

Getting error message "The section is not perpendicular in this view: select again."

ArekTRI
12-Amethyst

Getting error message "The section is not perpendicular in this view: select again."

Hi Creos,

 

I am facing this error which was registered as SPR 1410164.

https://www.ptc.com/en/support/article?n=CS51439&source=SPR%20Viewer

(Getting error message "The section is not perpendicular in this view: select again." when trying to arrows in a drawing view in Pro/ENGINEER and Creo Elements/Pro)

 

Is this bug repaired?

 

Thank you.

Arek

Creo 3 user
1 REPLY 1
StephenW
23-Emerald II
(To:ArekTRI)

Well, unlikely since it says it "works to product spec". Is this an offset x-sec? 

Resolution

Top Tags