Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hi there,
Every time I set a tolerance, I have to set the tolerance table to ‘None’ from the default type ‘General’, it’s really inconvenient, is there a way to set ‘None’ as the default type?
Regards,
Solved! Go to Solution.
Hi,
in https://www.ptc.com/en/support/article/CS237247 document you can find information related to your question.
Hi,
in https://www.ptc.com/en/support/article/CS237247 document you can find information related to your question.
Hi, Martin Hanak,
Really thanks, work like a charm!
Regards,
Lee