Loop in draft

[vgvk]

Does any one know how to use the loop option that is present in draft command?

Thanks...!!!

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[dschenken]

You need to select a surface. I recall that Creo will not initially highlight any edges, but when you select Next it will highlight a loop. If that's the loop you want, then click OK or Accept. Continuing to select Next will cycle through the available loops until it restarts; you can use Previous if it goes by one you want to go the other way in the sequence of loops.