Hello
i drawn a rectangle , how i put middle axis (orizontal and vertical) ,
i put in 3d but in 2d not see this
i put axis with sketch but i do not control dimension on it ? it's a tips and tricks for this 
tks for response
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
ACCEPTED SOLUTION
Accepted Solutions
One method is to put diagonal contruction lines through rectangle in the sketch and place datum point at intersection. When extruded it creates a centerline. this can then be shown in the 2D.
Use 'Show Model Annotations' to show the axis in your drawing (2d). It will be the 'model datums' tab within the Show Model Annotations window.
One method is to put diagonal contruction lines through rectangle in the sketch and place datum point at intersection. When extruded it creates a centerline. this can then be shown in the 2D.
