"Not defined" Datums points on curve surface (WF 4 build m160)
‎Mar 03, 2014
11:33 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Mar 03, 2014
11:33 AM
"Not defined" Datums points on curve surface (WF 4 build m160)
Pro Gurus,
I have a top level assembly where a housing has a curve surface. When I
create datum point on the curve surface, I select two assembly datum planes
in the "offset references" to locate my point horizontally and vertically.
The point snap into either horizontal or vertical datum plane depending on
my pick, the two green handle point disappear, and the box next to the
Datum Plane shows "not defined". Any idea, what I am missing?
Any help is greatly appreciated
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
I have a top level assembly where a housing has a curve surface. When I
create datum point on the curve surface, I select two assembly datum planes
in the "offset references" to locate my point horizontally and vertically.
The point snap into either horizontal or vertical datum plane depending on
my pick, the two green handle point disappear, and the box next to the
Datum Plane shows "not defined". Any idea, what I am missing?
Any help is greatly appreciated
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
Assembly Design
0 REPLIES 0