cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

where is the Shaft feature in Creo 2.0

SOLVED
Visitor

where is the Shaft feature in Creo 2.0

Insert > Advanced > Shaft in ProE Wildfire 5 for the On Point placement option.

I wonder where it is in Creo 2.0

Thanks


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions

Re: where is the Shaft feature in Creo 2.0

It's not in the ribbon. You need to customize the ribbon (look under "Commands Not in the Ribbon") or to use the command search tool

View solution in original post

9 REPLIES 9

Re: where is the Shaft feature in Creo 2.0

It's not in the ribbon. You need to customize the ribbon (look under "Commands Not in the Ribbon") or to use the command search tool

View solution in original post

Re: where is the Shaft feature in Creo 2.0

OK, I found Shaft by seach. Thank you very much!

Re: where is the Shaft feature in Creo 2.0

Hi Jack, can you please brief what this SHAFT command does?

Re: where is the Shaft feature in Creo 2.0

This SHAFT commond is similar to HOLE, but in opposite way. you can use Sketcher of SHAFT to draw a shaft profile (similar to sink hole profile), it is a good way to add feature to UDF'S.

Re: where is the Shaft feature in Creo 2.0

Can you apply this command to an assembly?

Re: where is the Shaft feature in Creo 2.0

I never tried but I expect you can't. The reason for that is that shaft it is a command that "add" material to the model, while in assemblies you can only remove material.

Re: where is the Shaft feature in Creo 2.0

I was just checking in follow up to a previous post that I had where a tube it pierce and the material is "moved". Which in modeling would most like be a feature that I was add and then subtract the middle.

http://communities.ptc.com/message/233564#233564

Thanks, Dale

Re: where is the Shaft feature in Creo 2.0

https://www.youtube.com/watch?v=VNES-Cplu4Y

this are available when u activate anatomic features

Announcements