cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

where is the Shaft feature in Creo 2.0

jzhang-3
3-Visitor

where is the Shaft feature in Creo 2.0

Insert > Advanced > Shaft in ProE Wildfire 5 for the On Point placement option.

I wonder where it is in Creo 2.0

Thanks


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions

It's not in the ribbon. You need to customize the ribbon (look under "Commands Not in the Ribbon") or to use the command search tool

View solution in original post

9 REPLIES 9

It's not in the ribbon. You need to customize the ribbon (look under "Commands Not in the Ribbon") or to use the command search tool

OK, I found Shaft by seach. Thank you very much!

Hi Jack, can you please brief what this SHAFT command does?

This SHAFT commond is similar to HOLE, but in opposite way. you can use Sketcher of SHAFT to draw a shaft profile (similar to sink hole profile), it is a good way to add feature to UDF'S.

Dale_Rosema
23-Emerald III
(To:jzhang-3)

Can you apply this command to an assembly?

I never tried but I expect you can't. The reason for that is that shaft it is a command that "add" material to the model, while in assemblies you can only remove material.

Dale_Rosema
23-Emerald III
(To:GabrielZaha)

I was just checking in follow up to a previous post that I had where a tube it pierce and the material is "moved". Which in modeling would most like be a feature that I was add and then subtract the middle.

http://communities.ptc.com/message/233564#233564

Thanks, Dale

https://www.youtube.com/watch?v=VNES-Cplu4Y

this are available when u activate anatomic features

Top Tags