cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Change Post-Processor Software Load Point

ScottJohnson
14-Alexandrite

Change Post-Processor Software Load Point

We have purchased and started using IMSpost and would like to change the load point when clicking on "Post a CL File" to IMS instead of Gpost. Is there a way to change this icon or replace it with a custom executable icon?

Post_Button.jpg


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions

Yes,  First create a mapkey to perform the functions you want.  We have one set up to create the .ncl file and then automatically post process the file.

Once the mapkey is working you can create an icon to run the mapkey.  This information is stored in a file called creo_parametric_admin_customization.ui that you will want to place in your loadpoint directory.  (usually C:\Program Files\PTC\Creo 3.0\M060\Common Files\text)

If you right click in the ribbon you will see the option to "customize the ribbon".  This activates the interface to create the above mentioned creo_parametric_admin_customization.ui file where  you can add the "tab" and then the custom icon you want that runs your mapkey.

View solution in original post

2 REPLIES 2

Yes,  First create a mapkey to perform the functions you want.  We have one set up to create the .ncl file and then automatically post process the file.

Once the mapkey is working you can create an icon to run the mapkey.  This information is stored in a file called creo_parametric_admin_customization.ui that you will want to place in your loadpoint directory.  (usually C:\Program Files\PTC\Creo 3.0\M060\Common Files\text)

If you right click in the ribbon you will see the option to "customize the ribbon".  This activates the interface to create the above mentioned creo_parametric_admin_customization.ui file where  you can add the "tab" and then the custom icon you want that runs your mapkey.

Hello Anthony,

did Bill's suggestion work for you?

If yes, please consider to mark his answer as "Correct Answer" to signal to the community that this thread has an answer.

Thanks,

Gunter

Top Tags