Community Tip - Visit the PTCooler (the community lounge) to get to know your fellow community members and check out some of Dale's Friday Humor posts! X
Hello erverybody,
I want to open a *.xmcd-file (which created by Mathcad 15) in Mathcad Prime 5.0, but failure. PTC Mathcad Prime 5.0.0.0 XMCD, MCD Converter can not convert too: error message is "Mathcad 15 M010 or higher is required to run the converter.".
And after each converting, I must restart the converter. Is it normal?
I used the data in xmcd converter as exercise, but converting was also fail.
Could you tell me what are the reasons for the two question above? Thanks for your antworts.
Best regards
Sun
Solved! Go to Solution.
For a download of Mathcad 15 see here: https://community.ptc.com/t5/PTC-Mathcad-Questions/New-service-release-of-Mathcad-15-M050/m-p/554723#M181000.
Success!
Luc
Yes! Thank you Luc!
Sorry, I thought the converter could run without MC15.
After MC15 was installed, all problems are solved. Thanks again.
BR
Sun