Programming issue . Fixing little program that calculates stresses

[SFares]

Hello,

Attached is a little program that calculates the normal and shear stresses. Load P can be applied at different angles. I'd like it to report the results for the loads, angles and von Mises stress. I can't get it to run. I am also wondering if i can include the units for area, section modulus, load......

Thanks,

Sam

[Werner_E · Accepted solution]

Like this?

[SFares]

Thank you so much!

i noticed if i change the area to 10 instead of 6 it doesn't solve.

i will start a new discussion about the same  sheet because i have other simple questions.

Thanks,

Sam