cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X

radial pattern of a cut

ptc-4835613
1-Visitor

radial pattern of a cut

Hi,

I am using PreoE2000i.

I made a cut on an extruded hexagon as shown in the figure and would like to make a radial pattern of it. How can I do that?

3 REPLIES 3

Set-up your cut down on the hex and insert an angle in the geometry of the cut. Use the angle when you pattern the cut about the inital centerline.

"Use the angle when you pattern the cut"

I have a square cut with proper dimensions, but dont know how to set an angle for it. I used a center line in the middle of square to give an angle but that wont work. :S

You need to have an angle in the hex dimension. You can make a centerline at an angle to the reference. Set this centerline to got through the center of your hex. Make the angle 0 if you must.

Announcements
Top Tags