Analysis measurements showing as annotations
‎Jul 11, 2013
10:28 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Jul 11, 2013
10:28 AM
Analysis measurements showing as annotations
Good morning -
I have a user who after doing an Analysis/Measure/Distance (or Length) is left with a 3D annotation that he can't erase, selector hide unless he closes the window and erases the file from his session. He's using my config, and I've never seen this, so I'm not sure what's going on - any ideas?
Thanks in advance -
Chrystal Johnstone
Red Dot Corporation
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
General
1 REPLY 1
‎Jul 11, 2013
10:45 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Jul 11, 2013
10:45 AM
I have a part that has a sketch on the top surface that is used for
engraving. The sketch clutters the drawing of the part too much so I
wanted to create a separate view for just the engraving. I've created a
simp. Rep. with the sketch excluded but I already have dimensioned views
on my drawing.
Is there any easy way to change an existing view to the simplified rep
view? The new views come up correctly once I set the model.
T
engraving. The sketch clutters the drawing of the part too much so I
wanted to create a separate view for just the engraving. I've created a
simp. Rep. with the sketch excluded but I already have dimensioned views
on my drawing.
Is there any easy way to change an existing view to the simplified rep
view? The new views come up correctly once I set the model.
T