cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Creo 3 M190 freeze on starting.

Go to solution
apigato
4-Participant
4-Participant
‎Aug 28, 2019 03:59 AM
‎Aug 28, 2019 03:59 AM

Creo 3 M190 freeze on starting.

Goodmorning everyone, I have a problem with the installation of Creo 3 M190, precisely it freezes as soon as it is started without the possibility of unlocking it. The same PC has Creo 3 M040 installed and has no problem. What can I check to resolve? Can it be the graphics driver?
 
Regards,
Andrea
Labels:
0 Kudos
Notify Moderator
ACCEPTED SOLUTION

Accepted Solutions
MartinHanak
24-Ruby III
24-Ruby III
(To:apigato)
‎Aug 28, 2019 06:43 AM
‎Aug 28, 2019 06:43 AM

Hi,

try renaming/deleting PTC sub-directory in %APPDATA% directory.


Martin Hanák

View solution in original post

Notify Moderator
2 REPLIES 2
apigato
4-Participant
4-Participant
(To:apigato)
‎Aug 28, 2019 04:51 AM
‎Aug 28, 2019 04:51 AM

I tried to install a later version of the graphics driver, but it is not solved.
0 Kudos
Notify Moderator
MartinHanak
24-Ruby III
24-Ruby III
(To:apigato)
‎Aug 28, 2019 06:43 AM
‎Aug 28, 2019 06:43 AM

Hi,

try renaming/deleting PTC sub-directory in %APPDATA% directory.


Martin Hanák
Notify Moderator
Announcements
NEW Creo+ Topics: PTC Control Center and Creo+ Portal


Contact Community Management
Top Tags