Issue with solid line through a hole feature i drawing mode

[�B_10498858]

I am using Creo Parametric Release 6.0 and Datecode6.0.6.0

Problem with solid center line showing up in a drawing view. Its a offset section with a sketch where there is two lines in 90 degree The section is showed by a full unfold, partial view.
Not sure if this is suppose to look like this or if its a bug or if there is any detail settings to hide the solid line that goes through the hole feature?

[MartinHanak]

Hi,

please attach some pictures. If it is possible pack your files into zip file and upload this zip file.

[�B_10498858]

Hi, here is 2 different drawing views with same issue. There is a solid line that i would like to have removed.

[MartinHanak]

---

@�B_10498858 wrote:

Hi, here is 2 different drawing views with same issue. There is a solid line that i would like to have removed.

---

Hi,

there is drawing option create_area_unfold_segmented. It is set to yes by default and you can switch it to no.

Unfortunately it only affects Area section views, not Total section views.

Fortunately there is also drawing option show_total_unfold_seam. It is set to yes by default and you can switch it to no.

It affects Total section views.

[�B_10498858]

Hi!

This works when you do not use partial view. Its when you also show the view as a partial that the solid line gets visible.
Best Regards

[MartinHanak]

I can't do anything about it.

[�B_10498858]

Thanks for your help anyway.