cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Make temporary dimensions in sketcher using hover & r key permanent?

danderson
11-Garnet

Make temporary dimensions in sketcher using hover & r key permanent?

Good Day Everyone,

Hoping this is a simple one with Creo 3. Looking at the following video on the learning exchange (support access required for link below), why would PTC not give us the ability to make the temporary dimensions permanent when hovering over existing sketch entities and pressing the r key?

Tutorial: Reviewing Layout Sketching

Or can we make the temporary dimensions permanent?

Thanks,

Don Anderson


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions
StephenW
23-Emerald II
(To:danderson)

This functionality (and video) is specifically for layout sketching, correct?

View solution in original post

2 REPLIES 2
StephenW
23-Emerald II
(To:danderson)

This functionality (and video) is specifically for layout sketching, correct?

Stephen,

You are correct that it is specifically for layout sketching. Would be nice to have some of this functionality in Creo Parametric Sketch mode.

Top Tags