cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Help us improve the PTC Community by taking this short Community Survey! X

Mass Properties

sstavos
1-Newbie

Mass Properties

I have a part that is made of Kydex T www.matweb.com has the density listed as 1.35 g/cc, in Wildfire 4.0 I have my units set to millimeter Kilogram Sec (mmKs).

If I go to Mass Props and set the Density 1.35 am I going get the correct values for the Mass? ( so far I don't think so)

Is there a config.pro option to turn off the scientific notaion in the Mass Properties dialogue box?

Does anybody have any ideas?

Steve


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1

Hi Steve,
You can fiddle till you get the right answer or you can set your Kydex T up
as a material and set the density in there. This is a more robust method.
Once you have made the material apply it to your part and you should see
accurate results from a mass query.

Hope this helps.


Regards, Brent Drysdale
Senior Mechanical Designer
Tait Radio Communications
New Zealand
DDI +64 3 358 1093
www.taitradio.com


Announcements
NEW Creo+ Topics: PTC Control Center and Creo+ Portal


Top Tags