Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
We have some users already using Creo 3 M040-M090 Datecodes and now planning to update to Creo 3 M130. Also few new users which need to install Creo 3 M130.
We have single image in software store configured for silent Creo install, which makes new install of Creo 3 M130 and not updating the current one on users system.
My Question is how to configure silent install process to detect existing install datecode and depnding on availibilty status decide for new install or update existing install of Creo datecode?
Any help will be much appreciated.
1-setup.exe -xml
2-setup.exe -xml "c:\softwares\creo3\creo3\creobase.p.xml" -xml "c:\softwares\creo3\creo3\pma.p.xml" -xml "c:\softwares\creo3\creo3\sim.p.xml" -xml
--------------------------
For creo help
creohelp.p.xml
For direct modeling
dma.p.xml