cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

The community will undergo maintenance on October 16th at 10:00 PM PDT and will be unavailable for up to one hour.

Unable to modify dimensions in sketch

NB_8458697
1-Newbie

Unable to modify dimensions in sketch

I am using Creo Parametric Release 7.0 and Datecode7.0.2.0

I'm unable to edit sketches. When attempting to define any sketch (stand alone, for extrusion, revolve, section, etc.) by editing dimensions, the dimension will open for editing, but will close again immediately before I can type in new value. I double click dimension to edit and it allows editing for a fraction of a second before locking again, as if I double clicked and then immediately hit "enter" to set.

Here are the errors that I faced
N/A

ACCEPTED SOLUTION

Accepted Solutions

Hi @NB_8458697,

 

Refer the instructions mentioned in the article CS352473. Let me know if this helps.

 

Regards,

Amol Lungare

View solution in original post

2 REPLIES 2
Dale_Rosema
23-Emerald III
(To:NB_8458697)

Hi @NB_8458697,

 

Refer the instructions mentioned in the article CS352473. Let me know if this helps.

 

Regards,

Amol Lungare

Announcements
NEW Creo+ Topics: PTC Control Center and Creo+ Portal


Top Tags