Community Tip - Visit the PTCooler (the community lounge) to get to know your fellow community members and check out some of Dale's Friday Humor posts! X
Is this a question or request for information?
Question
Your question is very vague, so you are not getting any responses.
Based on the file name, depending on your creo version, you can use the PTC system parameters (windchill parameters)
https://www.ptc.com/en/support/article/CS24526
For a drawing, you can use &dwg_name and &model_name
https://community.ptc.com/t5/3D-Part-Assembly-Design/How-do-I-remove-the-file-extension-from-the-file-name-parameter/m-p/726861#M119487
Hi @SU_10128205
Without clear details it will not be possible for community members to share much details.
Provide clear and more details for better help.
