Community Tip - Visit the PTCooler (the community lounge) to get to know your fellow community members and check out some of Dale's Friday Humor posts! X
Community,
I went from Creo 6000 to Creo 6040, and I cannot find the ifx fastener data, as shown highlighted below. I have never encountered this before, even with the Lite version. Is there a way to fix this? Thanks in advance.
Solved! Go to Solution.
In your picture you point to the AFX directory, not to the IFX directory?
Regards,
Oli
Hi ThoRig,
please refer to this post: https://community.ptc.com/t5/Assembly-Design/Can-t-Use-ANSI-Fasteners/m-p/666210#M20609
This will show the solution for your problem.
Regards,
Oli
Thanks for responding. I have that in my config file, and it still does not work.
In your picture you point to the AFX directory, not to the IFX directory?
Regards,
Oli
Good point. I missed that. I will take another look at it.
That was the problem. Thanks.