cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

The community will undergo maintenance on October 16th at 10:00 PM PDT and will be unavailable for up to one hour.

Can you create visible areas of views with shapes, or datums, or does it have to be splines?

CB_10360912
3-Visitor

Can you create visible areas of views with shapes, or datums, or does it have to be splines?

I am using Creo Parametric Release 9.0 and Datecode9.0.4.0

Is there a better way to create a visible area on a view using shapes, or datum planes rather than just using splines that you have to free hand draw?

Another question I have, is when drawing with splines, can you create a hard, one point turn if you're trying to create a square for example?

ACCEPTED SOLUTION

Accepted Solutions
Dale_Rosema
23-Emerald III
(To:CB_10360912)

Unless things have changed recently, splines are the only option.

 

The longer the distance between Pt1, Pt2(the "corner"), & Pt3 the sharper it will be, but you cannot get to a square corner.

View solution in original post

3 REPLIES 3
Dale_Rosema
23-Emerald III
(To:CB_10360912)

Unless things have changed recently, splines are the only option.

 

The longer the distance between Pt1, Pt2(the "corner"), & Pt3 the sharper it will be, but you cannot get to a square corner.

StephenW
23-Emerald II
(To:CB_10360912)

StephenW
23-Emerald II
(To:CB_10360912)
Announcements
NEW Creo+ Topics: PTC Control Center and Creo+ Portal


Top Tags